What is the Standard Air Knife?
A quiet, energy efficien♠♦★t way to clean, dry or cσ £γool parts, webs or conveyors. The Stand¥↑ard Air Knife utilizes the co♦φ↓¶anda effect (wall attachm≤α§≤ent of a high velocity fluid) to creφ✔ε∞ate air motion in its surrounβ±πdings. Using a small amount of c↔↔ompressed air as a power source, the↑€$ Standard Air Knife pulls in large vol★↔∞umes of surrounding air to λ♣produce a high flow, high velocity‌ε↕ curtain of air for ₩≠blowoff.

Why the Standard Air Knife?
Amplification ratios (entrained★""₹ air to compressed air) of 30:1 are ≠÷≈✔achieved with the Standard ∏¥σ•Air Knife, compared to 3:1₹↕≤ for drilled or slot≤Ω€→ted pipe. Air savings of 40% to 90%are possible when replacing these "ho★γ"memade" blowoff devices. Pay-ou→•≥•t is normally measured in  ∞☆weeks, not months or years. The Standaα​rd Air Knife dramaticall∑>y reduced "wind shear" by gradually i✔"≥ntroducing the entrained air t£★"o the ejected compressed air.

Noise level is typically'≤ε cut in half.The result is a high velocity, ✔ high volume sheet of air wiσ×th reduced noise level and air c ☆$ onsumption.

Overall length is 1" Ωααε(25mm) longer that th<σ₩e airflow length. The Standa$÷Ωrd Air Knife is available in al​↓&αuminum and stainless steel.

Drilled pipe or open jets, by"→☆ contrast, provide minimal air ±∏amplification. They also produce unac§∏ πceptably high noise l≠≠evels as the compressed air shears in♦∏ to the still air.

• 30:1 air amplification→♦
• No moving parts to wα₹<ear out
• Compressed air inlet on eac¶§"h end
• Special length Standard Air∏↕•✔ Knives available

(3) Model 2012 12" (305mm)
Standard Air Knives perform the dryin¶≥g cycle in this parts washer.
A Model 2012 12" (305mm)
Standard Air Knife opens mustφ≠λ∞ard packets prior to fill.
The Standard Air Knife blows ‌ εcontaminants from leather.